When we have a beloved car,for example, 2010 2011 Renault Megane,we hope that most system of it can be corresponding well-advanced.This is a normal psychology and today I will show you specific upgrade guide for 2010 2011 Renault Megane head unit double din stereo radio to help you achieve audio part of the car.

Many people are upgrading their car stereos to enjoy more entertaining life,and it’s achieved by driving car with a multimedia dvd display.Compared with factory stereo,a new radio has increased new functions in it to make our driving time more enjoyable and make us feel easy,I think this is one object of its production.

New radio for Renault Megane is different from some other autoradios,for its touch screen is placed farther than normal ones with occludes surround it.You needn’t to worry that it’s not convenient for you to watch the screen,however it can not only let you see clearer on shinning days,but also protect your screen from damage or collision,which will surely length its lifetime.This is an advantage and if you have doubts here is a picture to help you get a intuitive feeling:new stereo dvd with gps navigation bluetooth of 2010 2011 Renault Megane.

new stereo dvd with gps navigation bluetooth of 2010 2011 Renault Megane

After seeing Renault Megane head unit and you may still feel not enough,then I advice you to seek for more messages about it from the Internet,for example:http://www.seicane.com/in-dash-car-dvd-radio-player-specialized-for-renault-megane-with-gps-navigation-ready-built-in-3g-wifi-bluetooth-rear-view-camera-3d-map-c145.

2010 2011 Renault Megane head unit removal and installation:

1.Pry  trim panel above the glovebox and remove it

Pry trim panel above the glovebox and remove it

2.Remove the 3 torx screws

Remove the 3 torx screws

3.Pry  the trim panel and remove it

Pry the trim panel and remove it

4.Take out the screw on drivers’ side

Take out the screw on drivers’ side

5.Surround steering wheel pry off  it to gain approach to more torx screws

Surround steering wheel pry off it to gain approach to more torx screws

6.Recover the two screws

Recover the two screws

7.Pry the pillar trim off

Pry the pillar trim off

8.Take out the torx screws along the edge of the dash

Take out the torx screws along the edge of the dash

9.Take out 2 torx screws at each corner of the dash,then pull outer part of the rivet out

Take out 2 torx screws at each corner of the dash

10.Pry out the dash from the middle place carefully

Pry out the dash from the middle place carefully

11.Lifter back the dash

Lifter back the dash

12.Manage the dash out of the car carefully  over the steering wheel and store it in safe place

Manage the dash out of the car carefully over the steering wheel

13.Push the tabs at each side of the stereo down and then pull tabs back

Push the tabs at each side of the stereo down

pull tabs back

14.Disconnect the antennas at the back

Disconnect the antennas at the back

Removal procedure seems to be a little complex but not difficult to operate,your work is not over yet for you will continue to install  a new one in your car.

You should read cables connecting part of installation instructions carefully and act it according to right guide step by step,After right connection,install new unit into your car.

Turn on new installed radio and have a check for it.If it shows ok,then firm all removed screws back to original places and the same to other removed parts.Then whole procedure is finished.

Please be careful when you are installing the new unit,and you’d better ask one of your friends beside to help you.Be gentle to your car series and serious to every step.

If you want to know more stereos for some other cars,you can find them on some websites,for example:http://www.seicane.com.

And I have another article which is mainly about Renault Duster GPS radio dvd installation,you can have a look at it if you need.