Some car owners may worry about it’s too hard to install a new car stereo in a car. Actually, the installation is quite easy. If you want to replace your factory radio, a professional installation guide can be helpful for you. The following is a step-by-step 1999-2004 Jeep Grand Cherokee car radio installation guide from Seicane for your reference. Wish it can be helpful for you.
1999-2004 Jeep Grand Cherokee car radio after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
1999-2004 Jeep Grand Cherokee car radio installation steps
1.Remove the trim piece above cup holder with a lever.
Remove the trim piece above cup holder with a lever
2.Remove 2 screws behind the trim piece.
Remove 2 screws behind the trim piece
3.Gently pry around the side of trim panel with the lever and then remove the trim panel.
Gently pry around the side of trim panel with the lever and then remove the trim panel
4.Remove 4 screws which holds the factory radio in place.
Remove 4 screws which holds the factory radio in place
5.Take out the factory radio.
Take out the factory radio
6.Disconnect the smaller harness on the behind of the factory radio.
Disconnect the smaller harness on the behind of the factory radio
7. Check all the accessories for the new Seicane car radio.
Check all the accessories for the new Seicane car radio
8. Connect the harnesses to the back of the new Seicane car radio.
Connect the harnesses to the back of the new Seicane car radio
9. Connect the Seicane car radio to your original car radio ‘s plugs.
10.Install four screws and trim panel.
11.Install 2 screws behind the trim piece and the trim piece.
12.Turn on the new radio and have a comprehensive test if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
Wish the detailed installation guide for a 1999-2004 Jeep Grand Cherokee car radio can be helpful for you. If your dashboard is different from that shown in the guide above, please don’t worry, the installation is similar, and it won’t have much influence on the whole. For any questions, you can consult your dealer. If you don’t find a suitable stereo for your car, I’d like to recommend this amazing 1999-2004 Jeep Grand Cherokee car radio from Seicane to you, please click for more details:
With this multifunctional 1999-2004 Jeep Grand Cherokee car radio in your car, you are able to enjoy the GPS navigation convenience on all the way to your destination. The current location, 3D street view, landmark display, route planning, turn-by-turn direction and voice prompts are all provided for you to get the most accurate direction.
With a great radio tuner with 18 FM channels and 12 AM channels to be preset, you can choose your favorite station to get the instant news, traffic situation or entertainment while you are driving. Just take this Jeep Grand Cherokee car radio with you and have a pleasnant time from now on!