If you are not satisfied with your old original car radio because it cannot support some modern features, then you can think about replacing it with a brand new multifunctional car radio which will bring you great convenience and entertainment. If you own a 2016 Toyota Land cruiser 200 and also would like to upgrade your factory radio, then you can refer to the following 2016 Toyota Land cruiser 200 car radio installation instruction and take it as a reference.
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2016 Toyota Land cruiser 200 car radio installation instruction
1. Remove the padded covers from the two sides of the lower section at the center of the dash.
2. Next remove the silver Philips-head screw at the top and unclip the plastic retainer at the bottom of each side cover.

Next remove the silver Philips-head screw at the top and unclip the plastic retainer at the bottom of each side cover
3. Remove the side covers by pulling them towards the rear of the vehicle and slightly outwards.
4. Carefully remove the top cover by using a plastic flat removal tool.
5. Remove the air conditioning vents, and then disconnect the temperature control wires.
6. Remove the radio fascia and disconnect the wires at the back of it.
7. Pull out the lower segment containing the ashtray and power outlets.
8. Remove the air conditioning control and display section and its wiring connector.
9. Remove screws that fix the stereo on the dashboard.
10. Disconnect the connectors at the back of the stereo.
11. Check all the accessories for the new Seicane car stereo.
12. Connect the harnesses to the back of the new Seicane car stereo.
13. Connect the Seicane car stereo to your original stereo’s plugs.
14. Turn on the new Seicane car stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
15. Put the new Seicane car stereo into the dash.
16. Put everything into their original place.
Wish the above installation steps can be helpful for you to some degree. If you have any doubts, please don’t hesitate to seek help from your dealer, someone experienced or a professional. And for avoiding damage to either your car radio or your car, you can also directly go to a a car radio upgrade center and have the new car radio installed by a professional technician. Besides, it is essential for you to select an ideal car radio. If you have no ideas, here I would like to recommend a marvelous 2016 Toyota Land cruiser 200 car radio from Seicane to you. For more details, please click:
This car radio is running on the advanced Android 7.1 operation system and a high-quality quad-core CPU processor to facilitate its operation so as to upgrade your operation experience.
Under the wireless Bluetooth technology, you can pair your Bluetooth-enabled mobile phone with this car radio so as to get access to both Bluetooth hands-free calls and Bluetooth streaming music for greatest convenience and enjoyment.
What’s more, you don’t have to worry about getting lost in unfamiliar places even you don’t have good sense of directions. With the help of the worldwide real-time GPS navigation system, you are able to know where you are now and find the right way to reach any locations you would like to go to through turn-by-turn directions and voice prompts.
What are you waiting for? If you like this unit, just don’t forget to add it your shopping cart. Good luck!