On a long trip, it’s easy to get bored and tired. In that case, to refresh yourself and your passengers, an amazing car radio which can support a lot of entertainment options is much helpful for you. Since the factory radio usually comes with relatively few functions, so you can replace it with a new aftermarket radio to enjoy more advanced features. Please look at the image below, if you have the same dashboard, you can read this 2010-2013 Skoda SUPERB car radio installation guide as a reference to help with the installation.
2010-2013 Skoda SUPERB car radio after installation
Precautions for this installation:
1.Before you start up any work, park your car well and unplug the negative power cable to avoid any danger.
2.Please make sure that all fastened wires are isolated with electrical tape.
3.Please make sure the ignition is off to avoid short circuit.
2010-2013 Skoda SUPERB car radio installation guide
Step1: Remove the trim panel.
Please pry around the trim panel with a lever. While prying, please loosen the trim panel with your hand. When the trim panel is loosened, please remove the trim panel off the dashboard and gently place it aside for further removal.
2010-2013 Skoda SUPERB car radio installation step 1
Step2: Remove the four screws on the radio.
Please unscrew the four screws which are holding the radio at four corners with a screwdriver. Then keep them well in a small box for the installation of a new radio.
2010-2013 Skoda SUPERB car radio installation step 2
Step3: Take the factory radio out of the dash.
After the four screws are unscrewed, you can easily pull the factory radio out of the dash.
2010-2013 Skoda SUPERB car radio installation step 3
Step4: Disconnect the wiring harness.
Before you put the factory radio aside, please disconnect the wiring harness at the back of it.
2010-2013 Skoda SUPERB car radio installation step 4
Step 5: Connect the new Seicane car radio to the original wiring harness as the user manual or the wiring diagram shows.
Step 6: Turn on the new Seicane car radio to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
Step 7: Put the new Seicane car radio into the dash and install four screws.
Step 8: Install the trim panel into its original place.
It’s normal if you find the dashboard shown in the guide different from yours, please don’t worry, car dashboard varies from year to year. But the installation is similar and it won’t have much influence. If you think it too hard for you to install it on your own, you’d better have it installed by a professional.
Besides, you also need to make sure that your new radio can fit your car very well, so that it can be seamlessly installed in your car. If you are unsure about this, you can refer to the following 2010-2013 Skoda SUPERB car radio which comes with the latest configurations to upgrade your factory radio, please click:
With this Skoda SUPERB car radio in your car, you can navigate to any location you’d like with the help of the advanced GPS navigation system which can provide the latest traffic information by voice prompts. You can also use the built in Bluetooth for hands-free calls and streaming music so as to make your trip fill with safety and pleasure.
Just have a good time with this intelligent Skoda SUPERB car radio and keep your passengers entertained all the way in your car. Good luck to you!
https://buystromectolon.com/ – best place to buy stromectol