If you find your old original car radio is too far to be compatible with some modern features, why not think about replacing your factory radio with a brand new all-in-one car radio. First of all, please have a look at the following picture. It is a top 2010 2011 2012 2013 2014-2017 Lada Vesta car radio from Seicane after installation.
If you have the same or similar dashboard, you can refer to the following car radio installation instruction and follow the installation steps step by step.
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device-srd-400
2010 2011 2012 2013 2014-2017 Lada Vesta car radio installation instruction
1. Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside.

Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside
2. Remove screws that fixed the radio on the dashboard.
3. Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.

Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio
4. Unplug the connectors at the back of the factory radio.
5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure.

Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure
6. Put the new Seicane radio into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.
7. If everything is OK, firm screws into their original place.
8. Firm the panel on the new Seicane radio. Finally the new Seicane radio is installed and a comprehensive test should be conducted on the new radio.
Now can you fully understand all the steps mentioned above? If you cannot, please don’t be hesitated to seek help from your dealer, communicate with someone experienced or turn to a professional for help. Besides, it is essential for you to select an ideal car radio for your beloved car. If you have no ideas, here I would like to share an amazing 2010 2011 2012 2013 2014-2017 Lada Vesta car radio from Seicane with you. For more details, please click:
This marvelous car radio is loaded with comprehensive features to provide you with the best services, mainly including 3D GPS navigation system, FM/AM radio tuner, Bluetooth hands-free calls, Bluetooth streaming music, USB port or SD card connections, etc.
With the assistance of the built-in 3D real-time GPS navigation system, you can easily and quickly locate where you are and find the right way to reach your desired destinations through the turn-by-turn directions and voice prompts. And with dual zone function, this unit enables you to listen to your favorite music while navigating, which won’t have any negative influence on GPS navigation function.
Under the wireless Bluetooth technology, you can pair your Bluetooth-enabled mobile phone with this car radio, thus, you can freely dial, answer, reject and mute Bluetooth hands-free calls as well as listen to your favorite music streaming from your mobile phone.
Just don’t forget to purchase such a modern car radio at a comprehensive price. Good luck!