When you have got a car stereo of high configuration, have you consider installing it for your car independently? Perhaps you think it hard and worry that you cannot finish the whole installation successfully. But it is not impossible if you install the unit under a detailed installation guide. Here comes an easy-to-understand installation guide for a 2011 2012 2013 Hyundai Avante dvd player head unit, if you have the same vehicle type, you can refer to the following guide to help with your installation in the future.
2011 2012 2013 Hyundai Avante dvd player head unit after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7.For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2011 2012 2013 Hyundai Avante head unit installation instruction
1.The original head unit.
The original head unit
2.Remove the trim panel surround the head unit with a plastic knife.
Remove the trim panel surround the head unit with a plastic knife
3. Remove six screws that fixed the main panel.
Remove six screws that fixed the main panel
4.Loose the main panel and remove it softly with a plastic knife.
4-1. Loose the main panel and remove it softly with a plastic knife
4-2
5.Remove 4 screws that fixed the head unit on the dashboard.
Remove 4 screws that fixed the head unit on the dashboard
6.Gently pull out the original head unit. Then unplug the connectors at the back of the factory radio.
Gently pull out the original head unit. Then unplug the connectors at the back of the factory radio
6-1
7. Check all the accessories for the new Seicane head unit.
Check all the accessories for the new Seicane head unit
8. Connect the harnesses to the back of the new Seicane head unit.
Connect the harnesses to the back of the new Seicane head unit
9. Connect the Seicane head unit to your original stereo’s plugs.
10. Turn on the new Seicane head unit to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. Put the new Seicane head unit into the dash.
12. Put everything into their original place. All the installation is done.
Above is the 2011 2012 2013 Hyundai Avante dvd player head unit installation guide, wish it can be helpful for you. Please confirm that you are very clear about every step before the installation. If there is any question, it suggests you to seek beneficial advice from your dealer or a professional. What’s more, it is necessary for you to make sure you have an ideal head unit for your car. If you find your head unit is incompatible, I’d like to recommend an intelligent 2011 2012 2013 Hyundai Avante dvd player head unit from seicane to you, which comes with more advanced configurations compared with your factory radio. Please check out more details with the following link:
This all-in-one 2011 2012 2013 Hyundai Avante dvd player head unit from Seicane will be one of your best choices to replace your factory radio. You won’t get lost when you travel around an unfamiliar place thanks to the latest built-in GPS navigation system in high accuracy. Without keeping your hands off the steering wheel, you can also make, receive or reject hands-free calls as well as have music streaming with the synchronization between your enabled mobile phone and this unit via the strong Bluetooth technology. Besides, you can embrace more fun in car by playing region-free DVDs, CDs, FM/AM radio, etc. Wish you enjoy your every driving experience with this remarkable head unit in your car.