How to install 2009 KIA Sportage navigation dvd support 3-zone POP

This is a new unit after installation,aftermarket radio navigation system with WIFI touch screen of 2009 KIA Sportage.

new unit after installation,aftermarket radio navigation system with WIFI touch screen of 2009 KIA Sportage

Have a careful look at trim pane of it and then your factory radio’s,for most of you may haven’t changed the stereo for your car.

Knowing to install 2009 KIA Sportage navigation dvd support 3-zone POP is very necessary if you are willing to install one by yourself,in fact there are a lot of people make such a choice.

Facts shows that people nowadays are more likely to seek for entertainments from usual life.Though most of the time we are rushing for life but we also should learn to enjoy it.More and more people choose to buy KIA Sportage navigation radio unit because it will bring them much convenience and entertainments.

To be honest,you can of course ask a professional worker to do it,but it’s not difficult to achieve though you are not professional only if you can make adequate preparations for it and be careful enough.But simple doesn’t mean we can do as what we want without obeying any rules,here are some attentions for you.

Precautions for the installation and this new unit:

Please ensure that you have finished all parking series to keep your safety.If your car have operated at very fast speed for a long time or you feel the temperature is very high,when meeting these situations,you need to pay more attention to your new radio,new unit may enter heat protection mode at this time.If you have made up your mind to install a new unit,you can have a patient look at the following instructions and then operate the machine step by step.

2009 KIA Sportage factory stereo removal:

1.Pry downer part of trim panel with a hard lever,and you need to try several places of it to fasten it totally

Pry downer part of trim panel with a hard lever

try other places of it to fasten it completely

2.Then you can easily remove dashboard

you can easily remove dashboard

3.we can see that there are cables behind the dashboard,so we need to disconnect the cables.Some of them may be very firm,you can use a lever to do it

disconnect cables behind the panel

Use a lever to disconnect firm ones

4.Take down four screws with a screwdriver

Take down this screw and the other corresponding one with a screwdriver

Take down this lower screw and the other corresponding one with a screwdriver

5.After that you can remove the original radio off the car

remove the original radio off the car

6.Make cables that connected the radio and car disconnect

Make cables that connected the radio and car disconnect

Removal affairs has been finished,next we will go on learning how to install KIA Sportage aftermarket sat nav system.In fact it’s easier than front process only if you can do a good cables connection.

2009 KIA Sportage aftermarket navigation installation:

7.Correctly connect all cables to sockets of new radio and then set new head unit into place just for it

8.Install four screws to their original positions and make dashboard back to car

I believe that nothing will impede you from achieving this goal after patiently reading these specific introduction patiently.I guess there are still some people who are not very familiar with new installed unit,then I advice you to visit next website to gain detailed knowledge about it: http://www.seicane.com/2009-kia-sportage-multimedia-dvd-receiver-with-7-motorized-touchscreen-3g-wifi-ipod-input-support-gps-bt-radio-tuner-3-zone-pop-c023-1.

If you can provide your car gps dvd with good installation and maintain,it will surely make your usual life more richful.If you meet some problems that really troubles you,then you’d better ask someone who are professional to have a check for it,you are not professional after all.

For more car stereos,I know http://www.seicane.com/ has many choices,you can have a visit if you need.