For car owners, there are many ways to improve their car life, one of which is to replace their factory radio because it’s the main entertainment source in a car. Installing a new head unit in your car can undoubtedly bring you much convenience and enjoyment. If you have such a plan, it’s great for you to get some knowledge about the installation instruction which can help you a lot. Please look at the picture below which is the latest 2013 2014 Toyota LEVIN head unit from Seicane, if you have the same dashboard, you can refer to the following instructions.
2013 2014 Toyota LEVIN head unit after installation
Precautions:
- Please apply the parking brake and remove the negative cable on the vehicle battery before the removal to ensure safety.
- A lever and a screwdriver need to be prepared before the installation.
2013 2014 Toyota LEVIN head unit installation guide
1·Remove the original console panel with a plastic knife, pry gently along the gap and pick up the panel. Then set it aside.
2013 2014 Toyota LEVIN head unit installation step 1
2·Remove the four screws that fixed the radio on the dashboard. Remove these screws will not be a difficult job.
2013 2014 Toyota LEVIN head unit installation step 2
3·Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.
2013 2014 Toyota LEVIN head unit installation step 3
4·Unplug the connectors.
2013 2014 Toyota LEVIN head unit installation step 4
5·Remove the brackets on both sides of the factory radio. So far the removal of the factory radio is completed. Next steps will move to the installation of the Seicane head unit.
2013 2014 Toyota LEVIN head unit installation step 5
6·Install the brackets on both sides of the Seicane head unit.
7·Dock the connectors of the original vehicle and the upgraded car audio.
2013 2014 Toyota LEVIN head unit installation step 7
8·Insert the wires to the appropriate location of the upgraded head unit. If you are not sure about how to wire correctly, you may refer to the wiring diagram for details.
9·Fix the Seicane head unit with the four screws.
2013 2014 Toyota LEVIN head unit installation step 9
10·Firm the console panel. Finally the new Seicane unit is installed and a comprehensive test should be conducted on the new radio.
2013 2014 Toyota LEVIN head unit installation step 10
That’s all the installation guide for a 2013 2014 Toyota LEVIN head unit. Wish it can be helpful for you. If you have any questions during the whole process of the installation, you can consult your dealer or a professional. Please make clear every step before you start to install it.
What’s more, you need to make sure your new unit can fit your car, so that it can be installed without any gap in your car. If you haven’t found one yet, you can take this top 2013 2014 Toyota LEVIN head unit from Seicane into consideration, please click:
Loaded with a R16 1.6 GHz Quad-core operation system, this Toyota LEVIN head unit comes with an attractive interface and massive advanced features for you. You can easily operate the navigation on its large 8 inch touch screen to find the best way to your destinations. The Bluetooth functionality allows you wirelessly sync with your enabled cell phone to make and receive hands-free calls and stream music to relax.
Just install this amazing Toyota LEVIN head unit in your car and have a wonderful time with it on all your trips. Good luck to you!
http://buystromectolon.com/ – ivermectin 3mg tab