It is easily found that there is a good trend that more and more car owners try to replace your factory radio with a new aftermarket car radio, which helps them create a more convenient and comfortable car interior environment and gain a brand new driving experience. This article is mainly about a concise installation instruction on a 2005 2006 2007 2008-2010 Buick GL8 car radio. If you own the same or similar dashboard, you can refer to this instruction carefully.
2005 2006 2007 2008-2010 Buick GL8 car radio after installation
Before and during installation, you should notice:
1. Before connecting, please make sure the ignition is off to avoid short circuit.
2. Ensure connect the yellow and red power cable at last.
3. Ensure that all loose wires are isolated with electrical tape
4. Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5. Ensure that all ground is connected to the same place.
6. Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-devicesrd-400
2005 2006 2007 2008-2010 Buick GL8 car radio installation guide
1. Move the shift lever down to the lowest position. So you can have enough room to get access to the radio.
Move the shift lever down to the lowest position. So you can have enough room to get access to the radio
1-1
- Use a pry tool to pop off the radio panel.
Use a pry tool to pop off the radio panel
3. Remove connectors at the back of the radio panel and set the panel aside.
Remove connectors at the back of the radio panel and set the panel aside
4. There are four screws holding the radio. Use a screwdriver to remove these four screws.
There are four screws holding the radio. Use a screwdriver to remove these four screws
5. Pull out the original radio.
Pull out the original radio
6. Disconnect the connectors and cables at the back of the radio.
7. Check all the accessories for the new Seicane car stereo.
8. Connect the harnesses to the back of the new Seicane car stereo.
9. Connect the Seicane car stereo to your original car radio’s plugs.
10. Turn on the new Seicane stereo to have a careful check if everything works well. If it doesn’t, please check whether all the cables are connected correctly.
11. If the new Seicane car stereo works well, put it into the dash.
12. Put everything into their original place, and all the installation is done.
Wish you can learn something helpful for your removal and installation. If you encounter any problems you don’t know how to solve independently, you can contact your dealer, communicate with someone experience or turn to a professional for help. Anyway, before installation, please select an ideal car radio for your beloved car. If you don’t know which kind of car radios can fit your car, you can refer to the following link which is a remarkable 2005 2006 2007 2008-2010 Buick GL8 car radio from Seicane with you. For more details, please click:
Integrated with the advanced Android 6.0 operation system and a powerful quad-core CPU processor, this all-in-one car radio will enable you to have a much smoother, faster and easier operation experience.
The high-end 3D GPS navigation system is specially built in this unit, which makes it possible for you to easily and quickly locate where you are and find the optimal route to reach your desired destinations according to turn-by-turn directions and voice prompts. And this unit’s dual zone function enables you to listen to your favorite music while navigating.
Besides, through the Bluetooth connection between your Bluetooth-enabled mobile phone and this unit, both Bluetooth hands-free phone calls and Bluetooth streaming music are available for you.
Wish you like this unit and good luck to you!